Creating a prosthesis

Table of Contents

To use the Total Prosthetics Module for the Baltic Denture System, basically two options are available:

The models and their relation to each other (bite registration or vestibular scan or aesthetic plate) are scanned and loaded into the software.
To get the relation between upper and lower jaw, also a bite registration must be scanned.
Ideally, a Manager software like Manager 360° or similar is used, that is able to provide full integration with the impression steps previously taken. If a base border is provided the “baltic short flow” can be taken that may save a lot of time for the technician when creating the denture.

For Baltic Prostheses, the workflow may vary dependent on the provided input:

No models are provided on startup – loading a model is done within CAD
An all-in-one is provided
Functional impressions and a vestibular scan are provided for upper and lower jaw
Impression scans and a vestibular scan are provided for upper and lower jaw
A construction info file which provides information about the base border is loaded
Additional information located in the dental project (e.g. “uses milling”, “teethmaster selected”, overrides for default values in the sliders, …)
The scans have bad quality and must be repaired
The scans are not registered to each other
The user doesn’t have a valid license